HP Deskjet F4200 Serie Guide D'utilisation page 8
Masquer les pouces
Voir aussi pour Deskjet F4200 Serie:
- Guide d'utilisation (34 pages) ,
- Guide de configuration (8 pages) ,
- Guide de configuration (8 pages)
Publicité
Les langues disponibles
Les langues disponibles
Light status
All lights are off.
The On light is blinking.
The On light blinks quickly for 3
seconds and then is on steady.
The On light blinks for 20 seconds
and then is steady.
The Resume light is blinking.
The Check Print Cartridge light is
blinking.
The On, Resume, and Check Print
Cartridge lights are blinking.
The Resume and Check Print
Cartridge lights are blinking.
All lights are blinking.
Load originals for scanning and copying
You can load many different types and sizes of paper in the HP All-in-One, including letter
or A4 paper, photo paper, transparencies, and envelopes. For more information, see the
onscreen Help.
To load an original on the glass
1.
Lift the lid to the open position.
2.
Load your original print side down on the right front corner of the glass.
TIP:
object on the glass.
What it means
The HP All-in-One is turned off. Press the On button to turn on the
product.
The HP All-in-One is busy printing, scanning, copying, or aligning the
print cartridges.
You pressed a button while the HP All-in-One is already busy printing,
scanning, copying, or aligning the print cartridges.
You pressed the Scan button and there was no response from the
computer.
•
The HP All-in-One is out of paper.
•
The HP All-in-One has a paper jam.
•
The print cartridge door is open.
•
The print cartridges are missing or not seated correctly.
•
The tape was not removed from the print cartridge.
•
The print cartridge is not intended for use in this HP All-in-One.
•
The print cartridge might be defective.
Scanner failure.
Turn off the HP All-in-One, then turn it on again. If the problem persists,
contact HP Support.
The print cartridge carriage is stalled.
The HP All-in-One has a fatal error.
1.
Turn off the product.
2.
Unplug the power cord.
3.
Wait a minute, then plug the power cord back in.
4.
Turn on the product.
If the problem persists, contact HP Support.
To get the correct copy size, make sure that there is no tape or other foreign
Load originals for scanning and copying
5
Publicité
