Keysight E36150 Serie Guide D'utilisation page 87

Set the trigger source to Key/Immediate:
TRIG:SOUR IMM
To enable the output:
OUTP ON
To initiate the transient trigger system:
INIT:TRAN
Ramp Arb (Option E36150ADVU)
Step 1– Select Arb waveform
Press Arb to access the Arb selection menu. Then select Ramp.
Press Back to return to Arb main menu.
Step 2 – Configure the Ramp Arbs
Configure the Ramp Arb accordingly. Refer to the below table for details.
Parameter Available Key Settings
Arb Type Voltage or Current
Start Setting (I0 or minimum to maximum
V0)
End Setting (I1 or minimum to maximum
V1)
Delay (t0) 0 – 3600 s
Keysight E36150 Series User's Guide
Sets the output Arb type.
Default is Voltage.
Action required:
Press Arb Type to toggle between Volt and Curr.
Volt Selects voltage as output Arb type.
Curr Selects current as output Arb type.
Sets the setting before the ramp.
Sets the setting after the ramp.
Sets the delay time after the trigger is received but before the ramp starts.
Description
87