Publicité
Les langues disponibles
Les langues disponibles
Trigger Mode
Slope
Marker
Scope marker properties
Press Properties > Marker to access the scope marker properties.
Use the navigation keys to select the measurements that appear on the bottom of the display in Marker view.
Measurements apply to the portion of the waveform between the two markers. You can only select a maximum of
three measurements to be displayed.
140
Auto, Triggered or
Configures the trigger mode.
Single
Default is Auto.
Action required:
Press Trigger Mode to select a trigger mode.
Auto
Triggered
Single
Pos or Neg
Configures the trigger slope.
Default is Positive.
Action required:
Press Slope to toggle between Pos and Neg.
Pos (Positive)
Neg (Negative)
-
Select measurements to be displayed at the bottom of Marker view.
Configures the scope to display a single-sweep meas-
urement when a trigger is received, or automatically if a trig-
ger is not received. The scope continues running and waits
for another trigger when the measurement completes.
Configures the scope to display a single-sweep
measurement when a trigger is received. The scope stops
running when the measurement completes.
Configures the scope to display a single-sweep
measurement when a trigger is received. The scope
continues running and waits for the next trigger when the
measurement completes.
The measurement will be triggered on the positive (up-slope)
portion of the waveform.
The measurement will be triggered on the negative (down-
slope) portion of the waveform.
Keysight E36150 Series User's Guide
Publicité
