Publicité
Les langues disponibles
Les langues disponibles
Lower washer
Self Clean+
Certain usage and environmental conditions may result in some residue build-up or odor
in the washer drum. To prevent this build-up of residue or odor causing bacteria and keep
your washer drum fresh and clean, perform the Self Clean+ cycle at least once a month or
every 40 cycles. Perform the recommended procedure below when using the Self Clean+
cycle.
1. Remove all items from the washer drum and ensure the drum is empty. Laundry left in
the drum during the Self Clean+ cycle may be damaged.
2. Press POWER to turn on the washer.
3. Press Self Clean+.
4. Press and hold START/PAUSE.
CAUTION
If there is chlorine bleach left in the washer drum for an extended period of time, rust can
occur.
NOTE
• The water temperature for Self Clean+ is defaulted to Hot. This temperature cannot be
changed.
• In the case where residue is present in the washer drum, add liquid chlorine bleach
to the MAX level line in the main-wash compartment before starting the Self Clean+
cycle. Do not add the liquid chlorine bleach to the bleach compartment (This is only the
case for Self Clean+ cycle). Do not exceed the max line. Do not use or mix any other
detergent or chemicals during the Self Clean+ cycle. If necessary, run a RINSE+SPIN
Cycle after the Self Clean+ cycle has completed to help remove any remaining residue.
Self Clean+ reminder (
• After 40 washing cycles, the Self Clean+ LED reminder icon and the Self Clean+ cycle
LED will blink on the control panel for an hour and then turn off automatically.
• The reminder will appear on the control panel for 5 additional consecutive cycles
before turning off. The next reminder will not appear until another 40 cycles have been
completed.
FlexWash_WV9600M_DC68-03768B-07_EN.indd 59
)
English 59
2019-05-23 PM 2:53:32
Publicité
