Publicité
Les langues disponibles
Les langues disponibles
• In the case where residue is present in the washer tub, add 1/3 cup (2.7 fl. oz., 80 ml)
of liquid chlorine bleach directly to the empty tub before you start the Self Clean cycle.
Do not use or mix any other detergent or chemicals during the Self Clean cycle.
• If necessary, run a RINSE+SPIN Cycle after the Self Clean cycle has completed to help
remove any remaining residue.
CAUTION
• Check the washer tub before using the Self Clean cycle. Remove any remaining water
in the tub by running a Spin Only cycle prior to starting the Self Clean cycle.
• If there is chlorine bleach left in the washer tub for an extended period of time, rust
can occur.
Self Clean reminder (
• After 20 washing cycles, the Self Clean LED reminder icon and the Self Clean cycle LED
will blink on the control panel for an hour and then turn off automatically.
• The reminder will appear on the control panel for 5 additional consecutive cycles
before turning off. The next reminder will not appear until another 20 cycles have been
completed.
Fabric softener/bleach compartment
Both the fabric softener compartment and the bleach compartment on the upper washer
are not removable by design to facilitate visual feedback to users. To clean the softener
compartment, follow these instructions. Cleaning the bleach compartment is basically the
same.
FlexWash_WV9600M_DC68-03768B-07_EN.indd 57
)
1. Open the top door, and then remove
the softener cap.
2. Use a soft brush (for example, a
toothbrush) to clean inside the
compartment and remove impurities.
3. Run the RINSE+SPIN cycle to rinse the
compartment. After supplying water
and draining 5 times, the 18-minute
cycle completes with the final spin
process.
English 57
2019-05-23 PM 2:53:32
Publicité
