Installation Location; Safety Codes And Standards; Electrical Safety - Bosch HDIP056U Instructions D'installation

IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
WARNING
Hidden surfaces may have sharp edges.
▶ Use caution when reaching behind or under appliance.
▶ Wear gloves to avoid cutting fingers on sharp edges
during installation.
1.5 Installation location
To eliminate the risk of burns or fire by reaching over
heated surface units, cabinet storage space located above
the surface units should be avoided. If cabinet storage is
to be provided, the risk can be reduced by installing a
hood that projects horizontally a minimum of 5" (12.7 cm)
beyond the bottom of the cabinet.
Verify that cabinets above the range are a maximum of
13" (330 mm) deep.
1.6 Safety codes and standards
This appliance complies with the latest version of one or
more of the following standards:
¡ CAN/CSA C22.2 No. 61 - Household Cooking Ranges
¡ UL 858 - Household Electric Ranges
¡ ANSI Z21.1b-2012 Household Cooking Gas Appliances
¡ Installation must conform with local codes or, in the ab-
sence of local codes, with the National Fuel Gas Code,
ANSI Z223.1/NFPA 54 or, in Canada, the Natural Gas
and Propane Installation Code, CSA B149.1.
It is the responsibility of the owner and the installer to de-
termine if additional requirements and/or standards apply
to specific installations.
1.7 Electrical safety
¡ Installer - show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.
¡ If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
¡ Local codes vary. The installer is responsible for ensur-
ing that the installation, connections, and grounding
comply with all applicable codes. The manufacturer is
not responsible for any issues associated with the im-
proper installation of this product.
¡ Be sure your appliance is properly installed and
grounded by a qualified technician in accordance with
the National Electrical Code ANSI/NFPA 70 latest edi-
tion and local electrical code requirements.
¡ Only a power supply cord kit rated for this appliance
and marked "For Use With Ranges" shall be used.
¡ Refer to the rating plate for more information.
→ "Rating plate location", Page 19
WARNING
Before you turn on power supply, make sure all controls
are in the OFF position.
For appliances equipped with a cord and plug, do not cut
or remove the ground prong.
▶ It must be plugged into a matching grounding type re-
ceptacle to avoid electrical shock.
▶ If there is any doubt as to whether the wall receptacle is
properly grounded, the customer should have it
checked by a qualified electrician.
ELECTRIC SHOCK HAZARD
Disconnect power before installing or servicing. Before
▶
turning power ON, be sure that all controls are in the
OFF position.
▶ DO NOT remove connections.
▶ DO NOT use an extension cord.
▶ Improper grounding can result in a risk of electric
shock.
▶ Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you plug in an electrical cord, be sure all controls
are in the OFF position.
Before installing, turn power OFF at the service panel.
▶ Lock service panel to prevent power from being turned
ON accidentally.
GROUNDING INSTRUCTIONS
▶ This appliance must be grounded.
Grounding reduces the risk of electric shock by provid-
▶
ing a safe pathway for electric current in the event of a
short circuit.
▶ Be sure your appliance is properly installed and
grounded by a qualified technician.
▶ Installation, electrical connections and grounding must
comply with all applicable codes.
en-us
5