Hach SC4500 Instructions D'utilisation page 5

2.2 Icons used in illustrations
Manufacturer
supplied parts
2.3 Product overview
The conductivity module lets a digital SC Controller connect to an analog sensor. The module
connects to one of the analog module slots (slot 3 or 4) in the controller.
For calibration and operation of the sensor, refer to the sensor user manual and the SC Controller
documentation.
2.4 Product components
Make sure that all components have been received. Refer to
damaged, contact the manufacturer or a sales representative immediately.
Figure 1 Product compoments
1 Module connector
2 Conductivity module
2.5 Modbus registers
A list of Modbus registers is available for network communication. Refer to the manufacturer's
website for more information.
Section 3 Installation
Multiple hazards. Only qualified personnel must conduct the tasks described in this section of the
document.
Electrocution hazard. Remove power from the instrument before this procedure is started.
User supplied parts Look
Figure
3 Label with wiring information
D A N G E R
D A N G E R
Do one of these
Listen
options
1. If any items are missing or
English 5