Miller SUBARC STRIP DRIVE 100 Manuel Du Propriétaire page 20

5-2. Brush Inspection And Replacement
1
Tools Needed:
Notes
OM-254 238 Page 16
3/8 in. (9.5 mm)
Minimum Length
Replace
Damaged
Brushes
3
2
3/4 in. (19 mm)
New Length
1 Brush Cap
2 Spring Clip
3 Brush
Remove brush cap. Remove spring
clip and brush.
Replace brush if it becomes chipped
or broken, or if less than 3/8 in. (9.5
mm) of brush material is left.
Install brush so curved surface on
end of brush matches curve of motor.
Reinstall spring clip and cap.
Repeat procedure for other brush.
254 540-B / S-0816