Magmaweld ID 65 PX Mode D'emploi page 26

26 Maintenance and Service
MAINTENANCE AND SERVICE
EN
• Maintenance and repairs to the machine must be carried out by a qualified personnel. Our company will not
be responsible for any accidents that may occur by unauthorized interventions.
• Parts that will be used during repair can be obtained from our authorized services. The use of original spare
parts will extend the life of your machine and prevent performance losses.
• Always contact the Magmaweld or an authorized service designated by the Magmaweld.
• Never make interventions yourself. In this case the macufacturer warranty is no langer valid.
• Always comply with the applicable safety regulations during maintenance and repair.
• Before performing any work on the machine for repair, disconnect the machine's power plug from the power
supply and wait for 10 seconds for the capacitors to discharge.
4.1 Maintenance
Daily Maintenance
• The consumables on the torch should be checked regularly and replace if worn
or damaged. Make sure that these materials are original products for long-term
use and high performance.
Every 3 Months
• Do not remove the warning labels on the device. Replace the worn/torn labels
with the new ones. Labels can be obtained from the authorized service.
• Check your clamps and cables. Pay attention to the connections and the
durability of the parts.
• Replace damaged/defective parts with new ones.
Never make additions to/repair the cables.
• Ensure adequate space for ventilation.
Every 6 Months
• Clean and tighten fasteners such as bolts and nuts. Check the workpiece clamp and
cables. Open the side covers of the machine and clean with low pressure dry air.
Do not apply compressed air to electronic components at close distance.
• Make sure the air filter is clean. If it is dirty, replace it with a new one.
NOTE: The above mentioned periods are the maximum ones that should be applied if no problems are
encountered in your device. Depending on the work load and contamination of your work environment,
you can repeat the above processes more frequently.
Never operate the plasma cutting machine when covers are open.
USER MANUAL
ID 65 PX / ID 65 P
www.magmaweld.com