Magmaweld ID 65 PX Mode D'emploi page 22

22 Operation
EN
USER MANUAL
The gas flow rate will be adjusted automatically by the machine when the gouging method is
Gouging
selected in automatic mode. The consumables of the torch should be changed in accordance
with the gouging method in this method. Pilot arc occurs as soon as you press the trigger.
The cutting is carried out along the work piece and the pilot arc goes out as soon as the
work piece is finished or when the gap becomes visible. You can then release your finger
from the trigger.
Adjustment Pot
The machine starts in automatic mode when it is turned on and no gas pressure graphic
(M/A: Manual / Automatic Mode)
is visible on the screen. The adjustment pot is only used for adjusting the current in the
automatic mode. By turning the pot left and right, the desired current value is adjusted
within certain tolerance ranges.
In automatic mode, the power supply adjusts the gas according to the torch type and
length. It automatically adjusts the optimum gas pressure. Adjustment of gas pressure by
the power supply provides both convenience and prevents users from making mistakes in
gas pressure settings.
Press the adjustment pot once to switch to manual mode and the gas pressure graph
is displayed on the screen. Current and gas pressure adjustments are made with the
adjustment pot in the manual mode.
Press the Current / Gas selection button and switch to the current or gas adjustment
tab. When you come to the Current tab, an arrow appears next to it. To adjust the current,
turn the adjustment pot to the right and left to the desired current value within certain
tolerances. If the arrows are in the middle of the gas pressure graph, it is set to the optimum
value suggested by the machine.
When you press the Current / Gas selection button and switch to the gas adjustment tab,
an arrow will appear next to it. The power supply automatically adjusts the gas pressure.
However, the user adjusts it within a certain tolerance range. When the adjustment pot is
turned to the right, the gas pressure will increase and the gas pressure graph move to the
right. When the adjustment pot is turned to the left, the gas pressure will decrease and the
gas pressure graph will move to the left. The most optimum gas pressure setting according
to the adjusted flow is the value indicated in the middle of the graph.
ID 65 PX / ID 65 P
www.magmaweld.com