Rotel U210CH1 Mode D'emploi page 30

minutes, the appliance will enter standby state and you can continue operating
the appliance.

Always turn off the milk frother and disconnect the power supply when not
use.
o
Only frothing without heating

According to the 1-4 steps in the section of "Frothing and heating".

Press the switch button for three times continuously within 2s, the indicator
will illuminate blue and blink, the frothing paddle will rotate for frothing milk
separately, but the heating element will not heat. And the appliance will
automatically stop rotating after operating, the indicator will illuminate red
again until unplugging the power outlet.

Note: During operation, you can stop operating by pressing the switch button
once.

When the appliance has stopped operating, pour out the frothed milk from the
spout and enjoy it.

Caution: Minimum 3 minutes rest time must be maintained between two
continuous cycles, otherwise, the appliance will enter self-protection state
automatically after working for 5 cycles continuously, the working indicator will
flash and the switch button will not be activated, after about 5 minutes, the
appliance will enter standby state and you can continue operating the
appliance.

Always turn off the milk frother and disconnect the power supply when not
use.
o
Only heating without frothing

Place the appliance on a flat surface.

Select mixing paddle according to your task. Then open the lid, insert the
mixing paddle onto the shaft on the bottom of jar.

Fill the jar with the desired amount of milk (To ensure good result, it is
recommended the initial temperature of milk shall be 10-15℃ ), and replace the
lid.

NOTE: the max milk quantity permitted to add is 200ml, to avoid milk
overflowing after mixing or frothing.

Place the jar on the power base and connect the plug into a power outlet. The
indicator will illuminate red.

Press the switch button twice continuously within 2s, the indicator will light
blue. Then the appliance will start to work. Once the temperature of milk has
achieved about 68±10℃ , the heating element will stop heating and the mixing
paddle will stop rotating automatically; the indicator will illuminate red again
until unplugging the power outlet.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use