Scheppach ksm 2000 Traduction Du Manuel D'origine page 12

Extraction for the lateral table, Fig. 16
For work on the lateral table, the extraction nozzle (D) is
removed from the traverse grinding and attached to the
traverse table by means of a clamping screw (E).
Maintenance
Prior to each maintenance and cleaning, the motor must
be turned off and the mains plug disconnected.
All protective and safety equipments must be mounted
again immediately after repair and maintenance work
have been completed.
Grinding belt replacement, Fig. 17
1 Fold out the sanding stop plate.
2 Open the protective screen.
3 Unfasten the wing nut on the extraction nozzle and pull
the latter one backwards.
4 Release the old grinding belt and remove it.
5 While placing the new grinding belt, observe the ar-
rows for running direction on the inside of the grinding
belt.
6 Tighten the grinding belt.
7 Attach the extraction nozzle to the grinding belt again
and fasten the wing nut.
8 Adjust the belt run while the machine is running.
Belt replacement, Fig. 18
1 Remove the belt protection (1)
2 Unscrew the bearing flap (2)
3 Unfasten the 4 motor attachment screws (3)
4 Release the clamping nuts (4): the belt is un-tight-
ened
5 Replace the belt
6 Fasten the clamping nut (4): the strip is tightened
7 Tighten the 4 motor attachment screws
8 Fasten the bearing flap (2) and the belt protection (1)
Further maintenance notices
• Always keep the table surfaces free of resin. Do not use
aggressive cleaning detergents!
• Remove larger grinding dust accumulations in the ma-
chine.
• Grinding belts must be rolled in towards the bearing,
DO NOT BEND!
• Grinding belts must not be suspended on nails since
this may lead to damages such as kinks or cracks.
• At the end of the working day and during longer breaks,
un-tighten the grinding belt on the machine.
All manuals and user guides at all-guides.com
We herewith declare, scheppach Fabrikation von Holzbear-
bei tungsmaschinen GmbH, Günzburger Str. 69, D-89335
Ichenhausen that the machine described below due to its con-
struc tion and design and in the version delivered by us complies
with the relevant provisions of the following EC Directives.
In case of a modification of the machine this declara tion ceases
to be valid.
Machine description:
Edge grinding machine
Machine type:
ksm 2000, Art. No. 8106 0101, 8106 0102
Relevant EC directives:
EC machine directive 98/37/EG (< 28.12.2009),
EC machine directive 2006/42/EG (> 29.12.2009),
EC Low voltage directive 2006/95/EWG,
EC-EMV directive 2004/108/EWG.
Applied harmonized European standards
EN 292-1, EN 292-2, EN 294, EN 60 204-1
Notified body within the meaning of Annex VII
TÜV Rheinland, Product Safety GmbH, 51101 Köln
Place, date:
Ichenhausen, 22.07.2009
Signature:
On behalf of Wolfgang Windrich (product manager)
EC Declaration of Conformity
english 13