Publicité
Les langues disponibles
Les langues disponibles
3. Remove the dipstick (12 Fig.21).
Do not lose the gasket when removing the
dipstick.
4. Clean the dipstick and the gasket.
5. Insert the dipstick into the opening.
6. Pull out the dipstick gauge.
- When the oil level is between the two marks
("a" and "b", see Fig.22), the tank contains
enough oil.
- When the oil level is below the
lower mark "a" (see Fig.22), it is necessary to
add oil with a clean funnel.
7. Check the gasket. Replace if damaged.
8. Tighten thoroughly the dipstick.
Attention! To prevent damage to the seal and the
thread of the cylinder head, the screw must not
be over-tightened.
b) When to change the oil?
Do the first oil change after 50 hours, then drain
every 250 hours or once a year.
c) Oil change
1. The ram must be in the original position.
Make sure all moving parts have stopped and
that the log splitter is unplugged.
2. Place a 4 liters container under the log splitter.
3. Unscrew the cap of the oil tank. Do not forget
the seal during removal.
4. Then tilt the machine (Fig.25.a) to drain the oil
from the tank.
If necessary, ask a second person to come and
help you hold the log splitter
5. Then tilt the machine so that the filling
opening is pointing upwards (Fig.25.b).
12
Fig.21
Fig.22
- When the oil level is between the two marks
(Fig.24), the tank contains enough oil.
- When the oil level is below the mark "a" (Fig.24),
then it is necessary to add oil with a clean funnel.
6. Check the seal. Replace if damaged.
7. Insert the dipstick into the hole and screw the cap
back on.
19
b) When to change the oil?
Do the first oil change after 25-30 hours; then drain
every 50 hours or once a year.
c) Oil change
1. The ram must be in the retracted position.
Make sure all moving parts have stopped and that
the log splitter is unplugged.
2. Remove oil tank cap.
3. Place a container that can hold 7 liters of oil under
the log splitter.
4. Unscrew the drain plug (located under the base of
the splitter) for the oil to flow (see Fig.26).
5. Insert the seal and the drain plug in place.
6. Pour hydraulic oil (approx. 5.5 liters) using a
clean funnel.
7. Clean the dipstick and the seal.
Fig.23
Fig.24
Page 41 / 64
Publicité
