Ribimex 042081 Manuel D'instructions Et D'utilisation page 34

a) The log splitter table can be hanged-up at three different levels:
580/770/1060mm
- Upper position: for logs with max length of 580mm.
- Middle position: for logs with max length of 770mm.
- Lower position: for logs with max length of 1060mm.
b) Adjusting the table
Changing the table level can be easily performed without any additional
tool or help, simply proceed as follows:
- Remove the safety lock (a) on both sides of support brackets.
- Slightly lift table up and pull it out towards you.
- Slip and insert the table onto the desired level support bracket
(according to the length of the log),
- Let the table settle down making sure that the rear table hooks are well
and firmly settle on the bracket support. Lock in place.
4.3- Electrical requirements
With a 230V~ 50Hz motor, the log splitter should be connected to standard 230V10% (50Hz1Hz).
The electrical supply must be fitted with protection devices of under-voltage, over-voltage, and
over-current as well as a residual current device (RCD), which maximum residual current rated at
0.03A.
Electrical connection rubber cables must comply with EN60245 which are always marked with
H07RN, and with cross section greater than 1.5mm
Wiring and Plumbing diagrams
For log splitter 5T PREHLS52 / 042081
4.4- Bleed the air
Always open the air bleed valve before starting operating the log splitter
4.4.1- For log splitter 5T PREHLS52 / 042081
- Loosen the air bleed valve (11 in Fig.12) (oil
tank cover) a few turns whenever the splitter is
being used.
2
.
For log splitter 8T PREHLS7T/V / 042091
4.4.2- For log splitter 8T PREHLS7T/V / 042091
- Loosen the air bleed valve (8 in Fig.13) (oil tank
cover) a few turns whenever the splitter is being
used.
Fig.10
Fig.11
Page 34 / 64