Publicité
Les langues disponibles
Les langues disponibles
WallPerfect W 625 I-Spray
Problem
Spray jet pulsates
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)
Device does not
function
Paint in the
ventilating hose
Poor covering
capacity on the wall
Warning
If the supply cord of this appliance is
damaged, it must only be replaced by a
repair shop appointed by the manufacturer,
because special purpose tools are
required.
Warning: Do not connect the blue
or brown wire to the earth
terminal of the plug! The
wires in this mains lead are
coloured in accordance with
the following code:
blue = neutral
brown = live
Cause
•
Coating material in
container running out
•
Nozzle seal worn
•
Air filter heavily soiled
•
Too much coating material
applied
•
Viscosity of coating material
too low
•
Distance to the object too
large
•
Too much coating material
applied
•
Device overheated
•
Diaphragm soiled
•
Diaphragm defective
•
Spray material is too cold
•
Highly absorbent surface
or paint with poor covering
capacity
•
Distance too large
Remedy
Refill
➞
Replace
➞
Change
➞
Turn material volume
➞
adjusting screw to the left (-)
Reduce distance
➞
Turn material volume
➞
adjusting screw to the left (-)
Unplug the power plug,
➞
let the device cool down
approx. 30 minutes, do not
bend the hose, check the
air filter, do not cover the
intake slots
Clean the diaphragm
➞
Replace the diaphragm
➞
Heat spray material
➞
maximum 40°C)
Cross spray (Fig. 11)
➞
Closer to the object
➞
GB
(to
29
Publicité
