WAGNER W 625 Manuel D'instructions page 36

GB
20. Important Note regarding Product Liability!
Due to an EC ordinance in effect since 01.01.1990, the manufacturer is liable for
his product only if all parts originate from or were approved by the manufacturer
and the devices are assembled and operated correctly. The use of other accessories
and spare parts can partially or completely invalidate the liability.
How the product is handled, including preparation of the work place and spray
paint as well as the final result, is the sole responsibility of the operator.
Wagner excludes any liability for damage which may arise from overspray, application
errors, touch-ups, or non-compliance with the instructions provided here.
21. Correction of Malfunctions
Problem
No coating material
emerges from the
nozzle
Coating material
drips from the
nozzle
Atomisation too
coarse
28
Cause
•
Nozzle clogged
•
Material volume setting
turned too far to the left (-)
•
No pressure build-up in
container
•
Container empty
•
Feed tube loose
•
Feed tube clogged
•
Ventilating bore clogged
(Fig. 12, 1)
•
Coating material assembly
at air cap, nozzle or needle
•
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
•
Material volume too large
•
Material volume adjusting
screw turned too far to the
right (+)
•
Nozzle contaminated
•
Viscosity of coating material
too high
•
Too little pressure build-up
in container
•
Air filter heavily soiled
WallPerfect W 625 I-Spray
Remedy
Clean
➞
Turn to the right (+)
➞
Tighten container
➞
Refill
➞
Insert
➞
Clean
➞
Clean
➞
Clean
➞
Union nut tighten
➞
Change
➞
Change
➞
Turn material volume
➞
adjusting screw to the
left (-)
Clean
➞
Dilute further
➞
Tighten container
➞
Change
➞