Publicité
Les langues disponibles
Les langues disponibles
WallPerfect W 625 I-Spray
15. Taking Out of Operation and Cleaning
Proper cleaning is the prerequisite for problem-free operation of the paint application
device. No warranty claims are accepted in case of improper or no cleaning.
1)
Turn the machine off.
2)
Divide the spray gun. Press the hook (Fig. 6 "click") slightly downwards. Turn the gun
front part and gun rear part against each other.
3)
Screw of the container and empty it. Pull out the suction tube with container seal.
4)
Preclean the container and feed tube with a brush. Clean the ventilating bore (Fig. 12, 1).
We recommend the use of a common household washing-up brush to
i
clean the container.
5)
Pour water or solvent into the container. Screw the container back on.
Do not use flammable materials for cleaning purposes.
6)
Assemble the gun again (Fig. 6).
7)
Turn on the machine and spray the water or solvent into a container or a cloth.
8)
Repeat the above procedure until the water or solvent emerging from the nozzle is
clear.
9)
Turn off the machine and divide the spray gun.
10)
Screw of the container and empty it. Pull out the suction tub with container seal.
CAUTION! Never clean seals, diaphragm and nozzle or air holes of the spray gun with
metal objects.
The ventilation hose and diaphragm are only solvent-resistant to a limited
extent. Do not immerse in solvent, only wipe.
11)
Pull the ventilating hose (Fig. 13, 1) at the top from the gun body. Screw off the valve
cover (2). Remove the diaphragm (3). Clean all the parts carefully.
12)
Remove the adjustment ring (fig. 14, 1) carefully from the union nut (2).
13)
Unscrew the union nut (Fig. 14, 2) and remove the air cap (3), nozzle (4) and nozzle seal
(5). Clean the air cap, nozzle seal and nozzle with a brush and water or solvent.
14)
Clean the outside of the spray gun and container with a cloth soaked in solvent or
water.
15)
Assemble the parts again (see "Assembly").
Assembly
The unit may only be operated with an integer diaphragm (Fig. 13, 3).
1)
Place the diaphragm (Fig. 13, 3)
of the valve. Also see the marking on the gun body.
2)
Place on the valve cover
3)
Place the ventilating hose
body.
4)
Slide the nozzle seal (Fig. 15, 5) with the groove (slot) facing forwards into the
nozzle.
with the pin facing upwards on the bottom section
(Fig. 13, 2) and screw it closed.
(Fig. 13, 1) on the valve cover and on the nipple at the gun
GB
25
Publicité
