In General; Description Of Components; Fitting The Lamp - Futurelight Scan H - 150 Mode D'emploi

2.1 Description of components

1 - Bracket
2 - Mirror
3 - Fastening screws
4 - Cooling fan
5 - Screws for bracket
6 - Sub-D-jack for HC-Controller

2. 2 Fitting the lamp

Install the lamps with the device switched off only.
Housing screws

2. In general

10 - DMX Input
11 - DIP switches for projector selection
12 - Operating LED
DANGER !
Unplug from mains before!
To insert the lamp (EFR 15V/150W) open the housing by
loosening the fastening screws at the side panels.
Do not install a lamp with a higher wattage! A lamp like this
generates temperatures neither the device nor the transformer
is designed for. Damages caused by non-observance are not
subject to warranty.
1 2
7 - Fuseholder
8 - Mains plug
9 - DMX Output