CLAS PE 4000T Mode D'emploi page 42

PE 4000T PE 4001T
RISK OF SLIPPING (Figure11)
If the area of interest of the lift is eventually contaminated by lubricant, clean it immediately.
Repair every oil leakage along the hydraulic circuit.
Keep the working area clean.
When the lift is at its minimum height, to avoid riscks of slipping it is recommended not
to walk upon the platforms, on the crossbars or on every part of the lift that has to be
lubricated regularly.
Minimize the risk of slipping by wearing safety shoes.
Picture 11
ELECTRICAL SHOCK RISK:
The risk of electrical shock in the isolated areas of the equipment has been shattered.
Do not use water jets, vapour solvents or paints near the lift and the control unit and be
careful to keep these substances away from the electrical board.
RISKS OF INAPPROPRIATE LIGHTING:
The operator, the installer and the maintenance personnel must always make sure that the
area where the lift operates has adequate lighting in accordance with the laws in force in
the country where the lift is installed.
RISKS RELATED TO IMPROPER USE:
During lifting and lowering operations, the operators must always keep the lift under
observation and must always operate it from the designed safety position.
The handling of the safety devices is strictly forbidden.
Never exceed the lifting maximum capacity.
Make sure that the vehicles that are about to be lifted do not have load on board.
It is essential to scrupolously follow all the rules in matter of use, maintenance and
safety contained in this manual.
42