If the vacuum's suction is reduced, this may
be because the bag needs changing. Raise
the floor nozzle off the floor, set the suction
force regulation to MAX, switch on vacuum
cleaner using the on/off button, and keep an
eye on the bag change indicator. If it is red,
the bag must be changed.
▪
Turn off and unplug cleaner.
▪
Remove the hose, open bag cover by pushing latch up with fingers and lifting bag
cover.
▪
Grasp the millboard at the top of the
dust bag and carefully remove the bag
from the vacuum cleaner.
▪
Throw the bag in the bin. Make sure that
there are no holes in it.
▪
Insert a new dust bag in the vacuum
cleaner. The vacuum cleaner must never
be used without a dust bag.
▪
Close the vacuum cleaner again.
▪
Always replace the bag after sweeping up large quantities of fine material such
as fine sand, cement, flour, etc.
o
Cleaning the motor filter (B)
▪
The motor filter can be found in the dust bag container. It protects the motor
from dust and should be cleaned at least twice a year, when it is dirty, or if suc-
tion force is reduced.
▪
Pull the filter holder up out of the vac-
uum cleaner
▪
Open the filter holder, and remove the
filter.
▪
Rinse the filter in tepid water, and allow
it to dry completely.
▪
Do not use a hair dryer or similar to dry
the filter
▪
Return the filter to the holder, and replace the filter holder in the vacuum
cleaner.
o
IMPORTANT! Never use the vacuum cleaner without a motor filter.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
Motor
Filter
37