Proline EXP1050 Manuel D'utilisation page 63

7. Wait for the indicator light on the ON/OFF button stops flashing, press the
steam button
8. Place an empty container underneath the steam tube and then turn the
steam knob anticlockwise towards the maximum steam position.
• Let the steam run until a small amount of water has run through the
appliance, which clears any residual water from the steam tube.
9. When water is discharged, turn the steam knob clockwise to the OFF
position.
10. Place the jug with milk under the steam tube.
11. Wait for the ON/OFF indicator light to stop flashing and then press the
steam button
12. Turn the steam knob anticlockwise to the maximum position and slowly
move the jug upwards to obtain creamier foam.
13. Once the volume of milk has doubled, fully immerse the steam tube into the
mik to heat it up to 66°C.
• You will know when the milk is hot enough because the jug will be
extremely hot to touch.
• Do not boil the milk otherwise this will spoil the flavour.
14. Once the jug has fully heated, stop the steam by turning the steam knob
clockwise to the OFF position.
15. Remove the jug and wipe the steam tube with a damp cloth to clean.
EXP1050 IB 2022.indd 61
.
The tip of the steam tube should be just
below the surface of the milk.
.
Maximum
steam
position
61
28/2/2022 9:09 AM