Inflation Instructions; Using The Boat - Gumotex THAYA Manuel De L'utilisateur

3. Inflation Instructions

Unfold and spread out the kayak. If you are going to use the
tracking fin, plug it into the bottom bracket (20). Prior to as-
sembly, inflate both seats and footrests. The method for using
the valve (21) is shown in Figure 2.
The Thaya kayak can be used in its single, double and triple
version – Refer to Figure 1.
Single version:
Fasten the inflatable seat (6) in the bottom bracket (15).
Thread the seat backrest straps (18) through the D-rings (17)
on the side barrels. Thread the strap ends through the plastic
seat buckle (22) – Refer to Detail A.
Fasten the rear footrest (8) in the bracket (14). Thread the
footrest strap through the plastic buckle in the bottom and
tighten it, refer to Detail B.
Double version:
Fasten the front inflatable seat (6) in the bottom bracket (14).
Fasten the rear inflatable seat (6) in the bottom bracket (15).
Thread the seat backrest straps (18) through the D-rings (17)
on the side barrels. Thread the strap ends through the plastic
seat buckle (22) – Refer to Detail A.
Fasten the front footrest (7) in the bottom bracket (16) un-
der the front board. Fasten the rear footrest (8) in the bottom
bracket (14). Thread the footrest strap through the plastic
buckle in the bottom and tighten it, refer to Detail B.
Triple version:
Fasten the front footrest (6) in the bottom bracket (14). Fas-
ten the central and rear seats (6) in the bottom bracket (15).
Thread the seat backrest straps (18) through the D-rings (17)
on the side barrels. Thread the strap ends through the seat
plastic buckle (22) – Refer to Detail A.
Fasten the front footrest (7) under the front board in the bot-
tom bracket (16). Thread the footrest strap through the plastic
buckle in the bottom and tighten it, refer to Detail B.
Inflate the air chambers in the following order: sidewall cylin-
ders (1) and the bottom (2).
A foot pump or piston pump with a valve adapter is the best
way of inflating the craft (the valve adapter is included in the
gluing set) – see Picture 2b. Prior to inflating the canoe, check
the valves. Set the valves to the closed position. For how to
use the valves – see Picture 2.
Inflate the air chambers until they are firm but not completely
stiff. The air chambers should provide a feeling comparable to
squeezing a ripe orange. You can check the exact operating
pressure by using a suitable pressure gauge (optional acces-
sory) – see Figure 2a.
The spanner for assembling the valves is an optional acces-
sory – see Picture 2c.
ATTENTION
The maximum operational pressure in air chambers is
0.02 MPa (sidewall cylinder); 0.05 MPa (bottom). If the
ambient temperature increases (e.g. owing to sunlight),
the pressure in the air chambers of the canoe can rise
rapidly. We recommend releasing some air from all air
chambers of the canoe after pulling it out of the water.
This will prevent possible destruction of the air cham-
bers. However, do not forget to continuously check
air pressure in the chambers afterwards, too. A corre-
sponding reduction in operating pressure is up to 20%
within 24 hours.
ATTENTION
When using the boat, always seal the valves with their
valve caps. This will keep dirt out of the valves. Dirt can-
cause leaky valve seals.

4. Using the boat

The Thaya kayak is designed for recreational use and water
tourism.
Whenever the kayak is used on waterways, Waterway Traffic
Rules should be observed. Operation of the Thaya a inflatable
canoe does not require any licence provided the people who
operate the canoe know the techniques of small boat opera-
tion within the scope necessary for its operation, as well as the
valid navigation rules of the particular country.
The Thaya kayak can be used on still or gently flowing wa-
ters up to Difficulty Grade WW 2. This is only a recommended
use, it always depends on the specific abilities of the user! Use
double-bladed kayak paddles with a length of approx. 210 cm.
People travelling in the kayak should sit in their seats and wear
flotation life-jackets. The manufacturer recommends using the
boat in sufficient water condition (see Control table - draught).
ATTENTION
Prior to every use of the boat, check whether it is neces-
sary to observe any special regulations, restrictions or
rules connected with the river, surface of water or area
in which you aim to operate.
The boat is not intended for towing a motor boat, it must
not be slipped or otherwise excessively stressed. In
case of emergency, use the handle to at bow of the boat
to tow. Sharp edged and pointed items carried in the
boat must be safely wrapped.
Place all valuables into a waterproof container and fas-
ten it to the boat.
Over time, sunlight adversely affects the rubber coating
of the boat; therefore, it is advisable to store the boat in
shade each time after use.
CAUTION:
• On large surfaces of water (seas, lakes) pay atten-
tion to water currents and off-shore breezes. Cur-
rents and breezes may make it impossible to return
to shore.
• The Thaya kayak should not be used in poor condi-
tions, such as In reduced visibility (night, fog, rain).
Specifications of the WW 2 difficulty grade – moderately
difficult:
•
Irregular waves and riffles, medium rapids, small whirls and
eddies, low vertical drops, small rapids in watercourse with
heavy meandering or poor visibility
•
Regular flow and low, regular waves, small rapids, simple
obstacles, frequent meanders and fast current of water.
ATTENTION
Pay extra attention to your choice of flotation life-jacket.
The flotation life-jacket should have a tag bearing de-
tails of its flotation capabilities and safety certification.
11