Gima SUPER VEGA Mode D'emploi page 13

•
Connect the short silicon tube 1 ,with filter antibacterial 8, to the suction connector 2.
The other tube, with one end connected to the filter must be connected with the other end to
jar's lid connector 3 where has been fixed the red float.
When the 90% of the volume of the jar is reached there is the activation of the security float
(the float close the aspiration connector on the jar) to avoid liquid penetration inside the
device. The device must be used on a plan of horizontal operation.
•
Connect the long silicon tube 4 to the other jar's lid connector 5
•
Connect the other end of the long silicon tube 4 to the probe plastic connector 6 then
connect the suction probe to it.
•
Connect the power cord to the device then connect the plug to the electrical mains supply.
•
Push switch 7 on position I to start suction
•
Once finished push switch on 0 position and unplug.
•
Unscrew the jar's lid and fill the jar 1/3 full or ordinary water (this for an easy cleaning
operations and an rapid reaching of the functionally vacuum) then rescrew the lid on the jar
correctly.
•
To extract the accessories and start with cleaning.
INSTRUCTION FOR USE
13