Abus FU8220 2WAY Instructions D'installation page 9

Learning
1. Set the Secvest wireless control unit into learning mode. Consult the instructions of the control unit for more details.
2. Activate one of the two tamper contacts of the external wireless siren to send a tamper message to the wireless
alarm system.
3. Make sure that the siren is recognised by your wireless control unit, then close the housing. In doing this, ensure
that the spring of the tamper contact sits correctly.
Settings on the control unit
The external wireless siren can acknowledge the set and unset of the alarm centre using the flashing LED bar. Consult
the relevant chapter of the Secvest installation manual for more details.
Maintenance
The flashing bar and siren should be checked on a regular basis. Both tamper contacts should be checked during
maintenance. Check whether water or insects have entered through the housing. If necessary, clean the equipment
accordingly and carry out preventative measures to stop future infiltration.
The batteries should be replaced every two years, or when a corresponding message is shown on the Secvest display.
This product complies with the requirements of the EU directive: 1995/5/EC "Directive on radio and
telecommunications terminal equipment and the mutual recognition of their conformity".
The declaration of conformity can be ordered from:
ABUS Security-Center GmbH & Co. KG
86444 Affing
GERMANY
www.abus-sc.eu
info@abus-sc.eu
9