EUROM PD2101 XXL Manuel D'utilisation page 17

Step 10 (if necessary): In order to attach
your patio heater to the underground, drill
three holes in the ground. Drill these three
holes at equal distance around the edge of
the base. Make sure that each bolt is
completely tightened using an open-ended
wrench/spanner.
Your terrace heater is ready for use.
Warning! Do not connect the terrace heater to the mains if you observe any damage
(whether to the heater, cable or plug), and do not connect it before you have fully
assembled it!
Use
Place the terrace heater outdoors in a large open space. Ensure that the floor is sturdy,
flat and fully horizontal. There must be no objects such as branches, parasols, tarpaulins,
curtains, furniture or any flammable objects whatsoever within a radius of 1 meter around
the terrace heater. Do not use the terrace heater when it is raining or in wet conditions.
Check for every use:
- if the device doesn't show signs of damage.
- whether the device is still securely firmed. Wind, rain or gravity can eventually
loosen the attachments.
- that the socket that you want to use:
* is earthed;
* gives out the correct voltage (220/240V~50Hz);
* has at least a 16 A fuse;
* is secured with a 30 mA earth switch;
* is located in a safe, dry place.
When everything is as it should be, you can place the plug in the socket and then press
one or both switches, whereupon the terrace radiator will begin to work.
Switch I pressed = 900 Watts
Switch II pressed = 1200 Watts
Switch I + II pressed = 2100 Watts
During the first couple of minutes after connection, two dark dots will be visible on the
surface of the heating elements. This is perfectly normal and does not affect its operation.
When you use the device for the first time (or for the first time in a long while), you will
have to closely observe the device for the first 10 to 15 minutes to be certain that it is
working without any problems.
17