Marmitek EASYCONTROL 6 Mode D'emploi page 5

the button selects the following channel or song. Press any button to stop the Scan func-
tion. The Scan function will automatically stop after 2 minutes.
[6] Mute
Switches the sound on or off. You can also turn the volume of your TV on or off whenev-
er you are in VCR, DVD or SAT mode. This means that you do not have to switch over to
TV mode.
[7] PROG +/-
Selects the next or previous channel on your TV or satellite receiver. In DVD mode it
selects the next or previous track.
[8] VOL +/-
Controls the volume. You can adjust the volume, also when you are in VCR, DVD or SAT
mode. You do not need to switch over to TV mode.
[9] INFO
Provides on-screen information for the device selected (if available).
[10] SETUP
This is where you program the remote control for use. This button gives access to some
of the secondary functions of certain audio/video equipment (Shift). Press the SETUP but-
ton and then the desired function button.
[11] Numeric keys 0-9
These work just like a normal remote control.
[12] AV
Selects an external audio or video source (via the A/V or Scart in).
[13] -/--
This button allows you, on some devices, to choose channels that have a number higher
than 9 (two digits). If you are using the Setup mode and are automatically searching for
codes, you can use this button to enter the code for the device.
[14] MENU
Activates the menu.
[15] EXIT
Exits the menu.
[16] OK
Confirms the menu selection.
[17] Navigation buttons
Up, down, left, right, to be used to navigate through the menu (TV, DVD etc.).
EASYCONTROL 6 5