Foreword; Inserting Batteries; Button Functions - Marmitek EASYCONTROL 6 Mode D'emploi

1. Foreword

You can operate up to 6 devices with the EasyControl 6 remote control: TV, VCR (video
recorder), CBL (decoder, set top box), DVD, Audio (CD, amplifier), SAT.
The remote control contains a large number of pre-programmed codes. These codes are
suitable for almost all currently available devices and must be programmed once before
use. There are various ways to do this:
a. By manually entering one of the codes for the relevant brand that can be
found in the accompanying code book (see figure 4.1).
b. By using Auto Search to find common brands (see figure 4.2).
c. By using Auto Search for all brands (see figure 4.3).
d. By manually checking all the codes (see figure 4.4).

2. Inserting batteries

(always use NEW AAA-alkaline batteries)
1. Open the battery compartment at the back of the remote control.
2. Insert 2 AAA-alkaline batteries. Ensure that the polarity is correct (+ and -) and
follow the instructions on the lid.
3. Carefully close the battery compartment.

3. Button functions

[1] (On/off)
Switches the last selected device off. Some appliances can also be switched on by pressing
this button.
[2] RED LED indicator
The indicator light flashes when the remote is operating or lights continuously while you
are programming the remote.
[3] TV, VCR, CBL DVD, SAT
You can select which device you want to operate by using these mode buttons. There are
a limited number of functions available for audio.
[4] LEARN
Programming button for learning the functions of your original remote control. See chap-
ter 4.5, Learning codes, for information about programming these codes.
[5] SHOWVIEW
You can use the ShowView or VideoPlus function of your video recorder with this button
(if your video recorder supports this function). If your video does not support this function,
the button can give access to the timer function or the menu of your video recorder.
When the ShowView/V+ button is used in other modes than the VCR mode (TV, CBL, SAT,
AUDIO), this button is often used for the Scan function. For example, in TV mode you can
change channels or when listening to a CD you can only listen to the intros. After 3 seconds,
4 MARMITEK