Télécharger Imprimer la page

EGAmaster 79602 Manuel D'instructions page 31

Publicité

Les langues disponibles

Les langues disponibles

Only original spare parts may be used. There is no warranty for damages and liability is
disclaimed, if non-original spare parts and accessories are used.
PROBLEM
Machine does not
start
• Trigger clamps
• Machine rotates too
slowly
• Motor sticks / jams
• Gearbox makes
loud noises
• Tool not able to be
clamped
• Reversing
• "drilling /
hammering" clamps
SPARE PARTS
PROBABLE CAUSE
• Air not connected
• Rotor rusted by huminity
• Vanes jam (worn)
• Gearbox blocks
• Contaminates in valve
• Operating pressure too low
• Rotor grinds on end plates /
cylinder bushing
• Gear parts jam
• Vanes worn or broken, broken
parts stick between rotor and
cylinder bushing
• No lubrication - ball bearings
have run dry, rotor has rubbed
on end plates
• Coarse impurities in motor area
jammes between rotor and
cylinder bushing
• Needle cages defective
• Toothing is clattering
• Ball bearing defectiv
• Drill chuk defective
• diameter of tool too small
• Dirt in reversing area
• Steel rollers clamps
SOLUTION
• Connecting and open air line
• Disasseble and clean motor,
check and test
service unit for function
• Disassemble motor, clean it and
replace worn
parts
• Disassemble and clean gearbox
and replace
worn parts
• clean sit
• Increase operating pressure (on
the machine)
to 6 bar
• Disassemble and clean motor,
replace worn
parts
• Disassemble and clean gear,
replace worn or
damaged parts
• Disassemble and clean motor,
replace worn
parts
• Disassemble and clean motor,
replace worn
parts
• Disassemble and clean motor,
replace worn
parts
• Disassemble and clean gearbox,
replace worn
parts
• Change drill chuck
• use bigger tool
• Clean machine
• Disassemble gear and replace
defective parts
31

Publicité

loading

Ce manuel est également adapté pour:

7960379604