Publicité
Les langues disponibles
Les langues disponibles
Motor running
If motor to be turned, does not at all of heavily after re-assembly, light tapping with a rubber
hammer on motor housing is helpful. The rotor places and comes into a free-wheel position
between the end plates. If not, check lengths of the rotor, cylinder bushing and vanes.
a. The vanes shall not jut out lateral of the rotor slots, but not project on the rotor.
b. Cylinder bushing has to be 0.08 mm to 0.10 mm longer than the rotor.
After finishing of reassembly make functional gauging by checking free speed and air
consumption as specified in "TECHNICAL SPECIFATION".
30
Publicité
