Télécharger Imprimer la page

EGAmaster 79602 Manuel D'instructions page 28

Publicité

Les langues disponibles

Les langues disponibles

28
OILER TYPES USED ON OR WITH OUR TOOLS
Oiler to mount on the machine or connect in the hose
Setting the oiler: The adjustment screw is visible after
removing the screw plug. The oil supply is decreased
by tightening the screw, and by loosening the screw,
sufficient to tighten or loosen the screw by ¼ or ½ of a
turn. When plugged, clean borehole (diam. 2mm) with
Correct setting: When under pressure and with the filler
screw open, the oil must bubble slightly. The filling
For stationary pneumatic machines and motors,
Setting of oilers: Shut off air supply. Open plug. Loosen
screwdriver turn back the tightened screw plug by ¼ to
½ of a turn and then lock again. No oils are to get into
the borehole "a" when filling. Close plug and open the
Correct setting: A piece of paper held for a short time in
front of the outlet must be coated with oil without drops
For installing in permanently equipped workplaces.
(Especially for type using service units – see accessories
The transparent supply containers allow for good
means of a screw driver via a set screw with a visible
dripping. (The set screw is above the lateral thread
connection – turning to the right for less oil; turning to
the left for more oil). The setting (2 to 5 drops per m
min air consumption) is to be carried out when air is
flowing through, i.e., when the machine is running.
more oil gets into the machine. In most cases it is
lasts for approx. 8 operating hours.
Line oiler
the lubrication is carried out by lined-up oilers for
horizontal or vertical installation.
visible lock nut with a socket wrench. Using a
air supply.
forming.
Transparent oiler
checking as well as for good setting possibility by
line
wire.
list)
/
3

Publicité

loading

Ce manuel est également adapté pour:

7960379604