Description; Preparation Before Use; Checking The Oil Level - SDMO Technic 7500 TE C Manuel D'utilisation

1.3.12 Safety guidelines for handling batteries
Danger

2. Description

1 Earth connection
2 Oil filler gauge plug
3 Oil draining screw
4 Fuel gauge
5 Fuel tank plug
1 Oil draining screw
2 Oil filler gauge plug
1 Fuel tap
1 Wheel
2 Air filter cover
1 Spark plug cap

3. Preparation before use

3.1. Positioning the generating set for operation
Choose a site that is clean, well ventilated and sheltered from bad weather.
Place the generating set on a flat, horizontal surface which is firm enough to prevent the set sinking down (under no circumstances
should the set tilt in any direction by more than 10°).
Store the additional supplies of oil and fuel within close proximity, whilst maintaining a certain distance for safety.
3.2. Earthing the generating set
Danger
To connect the set to the ground: Attach a 10 mm
driven 1 meter into the ground.

3.3. Checking the oil level

Before starting up the generating set, always check the engine oil level.
Top up with the recommended oil (see § Specifications) using a funnel, up to the upper limit on the dipstick.
Allow the generating set to cool down for at least 30 minutes before checking the oil level.
Important

Remove the oil filler cap-dipstick (fig. A - no. 2 & fig. B - no. 2) and wipe it.

Replace the oil filler cap-dipstick and pull it out again.

Check the level visually. It should be within the upper limit (fig. B - no. 3) and the lower limit (fig. B - no. 4) on the dipstick. Correct
as required.

Replace the oil filler cap-dipstick.

Wipe off excess oil with a clean cloth and check that there are no leaks.
Never leave the battery close to a flame or fire.
Use only insulated tools.
Never use sulphuric acid or acid water to top up the electrolyte level.
6 Fuel tap
7 Air filter
8 Choke
9 Ignition key
10 Recoil starter handle
3 Upper limit of gauge
4 Lower limit of gauge
2 Fixing clamps
3 Filtration elements nut
4 Paper element
2 Spark plug
The generating sets supply electrical current when in operation: risk of electrocution.
Connect the generating set to the ground at each use.
2
copper wire to the set's earth connection and to a galvanised steel earthing rod
Figure A
Figure B
Figure C
Figure D
Figure E
11 Circuit breakers
12 Electrical sockets
13 Starter battery
14 Exhaust silencer
15 Working hours counter
5 Oil filter
3 Fuel filter
5 Foam element