Publicité
Les langues disponibles
Les langues disponibles
Venting Requirements
• Vent system must evacuate to the exterior –
Outside (through the roof or side wall).
• DO NOT terminate the vent system in an attic or
other enclosed area.
•
Use rigid metal/aluminum vent only.
• NEVER use plastic vent or plastic vent cover.
• Always keep the duct clean to ensure proper
airflow.
• Calculate
the
following
installation:
1. Distance from the floor to the ceiling.
2.
Distance between the floor and the
countertop/cooking element.
3. Distance between the range hood and the
countertop/cooking element which is
recommended at 28" to 30''.
4. Height of hood and duct cover with the
cabinet.
For the most efficient & quiet operation:
• It is recommended that the range hood be
vented vertically through the roof through 6"
(15.3 cm) round metal/aluminum vent or
vented horizontally through the wall through a
rectangular vent measuring 3 ¼'' x 10''.
• The size of the vent should be uniform.
• If venting vertically, do not use more than
three 90° elbows. Do not install two elbows
together.
• Make sure there is a minimum of 24" (61 cm)
of straight vent between the elbows if more
than one elbow is used.
•
The length of vent system and number of
elbows should be kept to a minimum to
provide efficient performance.
• The vent system must have a damper. If roof or
wall cap has a damper, DO NOT use damper
(which is supplied) on top of the range hood.
•
Use duct tape to seal all joints in the vent
system.
• Use caulking to seal the exterior wall or roof
opening around the cap.
Height & Clearance
figures
before
Ceiling
heigh
23
Cabinet
height
Range
hood
height
Min: 28"
Max: 30"
t
Countertop/
Cooking element
36" standard
counter
height
Cabinet
Range hood
Publicité
