Technaxx TX-145 Mode D'emploi page 43

3.2 Use as ADDITIONAL CAMERA for TX-128 Set
The first camera has been matched with monitor in the factory already. The
image shows up when the kit is powered on. If users need to pair the camera
again or add an additional camera, operate as below:
Step one: Power on the monitor and camera.
Step two: Reset the camera to enter the pairing mode.
Step three: Enter the Match code interface on the monitor and click on the
match code.
Tips:
1) The camera can only perform the pairing in the reset state; the camera
needs a reset to perform the pairing mode.
2) If the camera does not pair with the monitor, click "Match Code" again to
try again.
3) If you need to replace a new camera, please click "X" on the monitor to
delete the channel and then click on match code.
6