Enabling/Disabling The Mute Function; Adjusting The Volume; Changing Settings For The Colour Monitor - Sygonix SY-3396992 Notice D'emploi

f) Enabling/disabling the mute function
It is possible to enable/disable the mute function only if the video door intercom system is in standby mode;
once enabled, the interaction with any of the outdoor units will not be possible.
When the mute function is enabled, the indoor unit plays no bell melody. For example, the mute function
can be used at night if you do not want to be disturbed.
• To enable or disable the mute function, press and hold down the "
beep is heard. Then, release the button again.
• When the mute function is enabled, the "
g) Adjusting the volume
• You can use the " " knob (11) to adjust the playback volume on the indoor unit (when talking to a visitor).
• The playback volume on the outdoor unit can be adjusted with the knob (24) (turn counter-clockwise to the left to
turn the volume up, and clockwise to turn it down).
h) Changing settings for the colour monitor
When the indoor unit monitor shows the camera image, you can set brightness and contrast using two knobs:
• " " knob (12): Contrast
• " " knob (13): Brightness
34
" LED (4) goes on.
" button (9) for approx. 4 seconds until a short