HQ Power HQPL11001 Mode D'emploi page 6

4.4 Installation
There must be a lamp fitted in each lamp holder, and each lamp
must be sealed correctly with its gasket. It is not safe to use the
chain with missing or incorrectly placed lamps or gaskets.
To install the chain after testing, proceed as follows:
1.
2.
3.
Make sure not to damage the insulation during installation. Do
not use sharp tools to install the chain. Do not fix the chain to
buildings or other supports using nails, staples, or other sharp,
conducting materials.
4.
4.5 Use
1.
2.
5. Cleaning and Maintenance
•
•
V. 02 – 18/10/2021
HQPL11001/HQPL11002/HQPL11003
Choose a suitable mounting spot. Make sure that the chain
cannot get damaged, for example by sharp edges, swinging
windows, doors, etc. Also make sure that the chain cannot
cause hazardous situations if it accidentally comes loose.
For example, avoid crossing passageways. Not suitable for
installation in cabinets, ceilings, or other enclosures. Not
suitable for installation under water.
To mount the chain, start at the side of the power plug.
Position the power plug near a mains outlet, but do not
plug it in yet. Make sure to leave enough power cable to
easily plug into the mains outlet without stress on the
cable.
Start mounting the chain in the desired location.
It is recommended to fix the chain to a support at least
every metre.
Plug the chain into a suitable mains outlet to switch it on.
Unplug it from the mains to switch off.
Once a month, inspect the plug, cable, insulation, and lamp
holders for degradation due to weather, UV light, or other
damage. If you notice any deterioration, stop using the
chain and dispose of it.
If a lamp is not working, unplug the chain immediately and
replace the lamp. See Fitting or Replacing Lamps for
detailed instructions. Use only replacement lamps of the
exact same type as stated in the specifications in this
manual.
6 ©Velleman Group nv