HQ Power HQPL11001 Mode D'emploi page 4

4. Installation
4.1 Inspection before Installation
1.
2.
3.
4.
5.
Only do this when the power is disconnected.
4.2 Fitting/Replacing Lamps
1.
2.
3.
V. 02 – 18/10/2021
HQPL11001/HQPL11002/HQPL11003
Take the chain out of the box and unroll it fully.
Make sure that the power plug is disconnected from the
power supply.
Check the plug, cable, insulation, lamp holders, and lamps
for damage:
Replace any damaged lamps. See Fitting or
o
Replacing Lamps for detailed instructions.
If you notice any other damage, do not use the chain
o
and contact your dealer.
Make sure that the lamp holders are dry and clean on the
inside and outside.
Check if the electrical connectors in the lamp holders are in
the correct position. One shall be flat at the bottom of the
socket, the other shall point upwards, as shown in the
image. If you find a socket with both connectors pointing
upwards, bend one down to match the other sockets.
OK
Make sure that the power plug is disconnected from the
power supply. Do not replace lamps during rain or other
inclement weather conditions.
To replace a lamp, carefully unscrew the faulty lamp.
Fold down the rubber gasket over the lamp holder. This
makes it easy to fit the lamp.
4
Not OK
©Velleman Group nv