Amana NTW4700YQ1 Guide D'utilisation Et D'entretien page 8

7.
Select LOAD SIZE
Select the Load Size setting most suitable for your load. Small
will add a low amount of water for smaller loads and Large
will add the most amount of water for large or bulky loads.
Garments need to move freely.
8.
Select WASH TEMPERATURE
Once you select a cycle, select the desired temperature by
turning the Wash Temperature knob to the appropriate setting
based on your load. All rinses are cold.
NOTE: Always read and follow fabric care label instructions to
avoid damage to your garments.
Wash Temperature
Hot
Some cold water is added to save
energy. This will be cooler than
your hot water heater setting.
Warm
Some cold water will be added, so
this will be cooler than what your
previous washer provided.
Cool
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
8
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed
or fade
Light soils
Wash Temperature
Cold
This is the temperature from your
faucet. If your tap cold water is
very cold, warm water may be
added to assist in soil removal
and help dissolve detergent.
9.
Select options, if desired
If you are using fabric softener, be sure to set the Fabric
Softener option knob to YES.
10.
Press START/PAUSE/UNLOCK
LID to begin wash cycle
Press the START/Pause/Unlock Lid button to start the
wash cycle. Filling is delayed for several minutes while load
balance is sensed. When the cycle has finished, the CYCLE
COMPLETE indicator will light. Promptly remove garments
after cycle has completed to avoid odor, reduce wrinkling, and
rusting of metal hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock Lid; the lid will unlock once
the washer movement has stopped. This may take several
minutes if the load was spinning at high speed. Then close
lid and press START/Pause/Unlock Lid again to restart
the cycle.
If lid is left open for more than 10 minutes, the water will
pump out automatically.
Delay in water fill
Filling is delayed for 2 to 3 minutes to check for load
unbalance. You will hear the hum of the spin prior to filling.
This is normal operation.
Suggested Fabrics
Dark colors that
bleed or fade
Light soils