Amana NTW4700YQ1 Guide D'utilisation Et D'entretien page 12

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.amana.com/help
If you experience
Washer not performing as expected (cont.)
Washer won't run Check proper electrical
or fill, washer stops supply.
working or wash
light remains on
(indicating that the
washer was unable
to fill appropriately)
(cont.)
Normal washer
operation.
Washer may be
tightly packed.
Washer not draining/ Empty pockets and use
spinning, loads are garment bags for small
still wet or spin items.
light remains on
Use a cycle with a low
(indicating that the
spin speed.
washer was
unable to pump
out water within
10 minutes)
The washer may be tightly
packed or unbalanced.
Check plumbing for correct
drain hose installation.
Drain hose extends into
standpipe farther than
4.5" (114 mm).
Too much detergent
causing suds to slow or
stop draining and spinning.
12
for assistance and to possibly avoid a service call.
Possible Causes
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not interrupt cycle.
Washer spins the dry load for several minutes before filling to determine if load
is balanced. You may hear the hum of the spins. This is normal.
Remove several items, rearrange load evenly in basket, and add
detergent. Close lid and press START/Pause/Unlock Lid.
Add only 1 or 2 additional garments after washer has started.
Small items may have been caught in pump or between basket and tub, which
can slow draining.
Cycles with lower spin speeds remove less water than cycles with high spin
speeds. Use the recommended cycle/speed spin for your garment. To remove
extra water in the load, select Drain/Spin. Load may need to be rearranged to
allow even distribution of the load in the basket.
Tightly packed or unbalanced loads may not allow the washer to spin correctly,
leaving the load wetter than normal. Evenly arrange the wet load
for balanced spinning. Select the Drain/Spin cycle to remove excess water.
See "Using Your Washer" for loading recommendations.
Check drain hose for proper installation. Use drain hose form and securely
attach to drainpipe or tub. Do not tape over drain opening. Lower drain hose if
the end is higher than 96" (2.4 m) above the floor. Remove any clogs from drain
hose.
Always measure and follow detergent directions for your load. To remove
extra suds, select Rinse/Spin. Do not add detergent.
Solution