Vr2-L, (Lights) - Quickie Salsa M2 Mini Manuel D'utilisation

Charging and programming socket:
WARNING!
This socket should only be used for programming and
charging the wheelchair .
WARNING!
This socket should not be used as a power supply for
any other device. Connection of other electrical devices
may damage the control system or affect the EMC
performance of the wheelchair
See section 11 about charging.
The programming socket will enable an approved
Sunrise Medical authorised dealer to re-programme your
wheelchair and also gain useful information when tracing
any faults. When the wheelchair leaves the factory, the
parameters of the controller are set to default.
WARNING!
Programming the controller of the wheelchair is only
allowed through authorised personnel trained by Sunrise
Medical. Incorrect controller settings could cause driving
outside the safe limits and could result in damage or
injury.
WARNING!
SUNRISE MEDICAL does not accept responsibility for
damages which result from unexpected stopping of the
wheelchair or inappropriate programming or unauthorised
use of the wheelchair .
R-net Control
Please refer to your R-net Owner's Manual for
details.

7.2 VR2-L, (Lights).

There are common controls between the VR2 and the
VR2-L control systems where a control differs it will be
described below. All common controls can be found on
the previous page.
Rev.3.0
Lights and indicators:
The SALSA can be equipped with lights and indicators.
Where lights are not factory fitted, they may be fitted
as an optional extra by an approved Sunrise Medical
authorised dealer.
WARNING!
Ensure that the lights and indicators are functioning
correctly and lenses are clean before going outdoors at
night.
Indicators:
To turn on the wheelchairs indicators operate the required
button either left or right, the associated LED will also
illuminate continuously.
Depress the indicator button to turn off the indicator and
the associated LED
CAUTION!
If the LED flashes rapidly either a total short circuit, a
single lamp open circuit or a total open circuit in the left or
right indicator circuit has been detected
Main lights:
To turn on the wheelchairs lights operate this button, the
associated LED will illuminate continuously.
Depress the light button to turn off the lights and the
associated LED
CAUTION!
If the LED flashes a short circuit in the lighting circuit has
been detected.
Hazard warning lights:
To turn on the wheelchairs hazard warning lights operate
this button, the associated LED will flash at the same rate.
The left and right turn indicator LEDs will also flash.
Depress the hazard warning button to turn off the lights
and the associated LED.
CAUTION!
If the LED flashes rapidly either a total short circuit, a
single lamp open circuit or a total open circuit in the entire
indicator circuit has been detected
43
SALSA M Mini
2