Parkside PSHL 2 A1 Consignes D'utilisation Et De Sécurité page 11

z Troubleshooting
Error
The filter does not darken in a
normal way or flickers.
The reaction is slow.
The visibility is poor.
The welding helmet slips.
z Warranty and service
information
Creative Marketing Consulting GmbH
warranty
Dear customer, the warranty for this device is
3 years from the date of purchase. In the event of
product defects, you have legal rights against the
retailer of this product. Your statutory rights are
not limited in any way by our warranty detailed
below.
Warranty terms
z z
The warranty period begins on the date of pur-
chase. Please keep the original receipt in a safe
place. This document is required as your proof of
purchase. Should this device show any fault in
Troubleshooting / Warranty and service information
Cause
The protector does not darken in a
normal way or flickers.
The arc sensor is not clear.
The welding current is too low.
The ambient temperature is too
low / high.
The sensitivity is too low.
The protector / the protective
screen is dirty.
The protective film on the protective
screen was not removed.
The ambient light is not sufficient.
The wrong darkening shade has
been set.
The headband 5 has been put on
incorrectly.
materials or manufacture within 3 years from the
date of purchase, it will be repaired or replaced –
at our choice – by us free of charge. This warranty
is conditional on the defective device and the
receipt of purchase being presented within the
3 year warranty period, and that there is a brief
written description of the nature of the defect and
of the date it arose.
If the defect is covered by our warranty, you will
receive the product which has been repaired or a
new product. A repair or exchange of the device
does not begin a new warranty period.
Extent of warranty
z z
The appliance has been manufactured to strict
quality guidelines and meticulously examined
before delivery.
Solution
Clean the protector or replace it.
Clean the arc sensor's surface.
Set the sensitivity to the maximum
degree.
Only use the welding helmet in
temperatures between -5 °C and
+55 °C.
Set the sensitivity to a higher
setting.
Clean the protector and the
protective screen.
Remove the protective film.
Apply more light to your work
surroundings.
Reset the darkening shade.
Put on the headband 5 again
tighter.
GB/IE/NI 11