Parkside PSHL 2 A1 Consignes D'utilisation Et De Sécurité page 10

... / Cleaning and Maintenance / Environmental instructions and disposal ...
To replace the UV filter/solar cell, pull the
„ z
16
bracket at the bottom edge of the filter over
the two protruding locking pins and outwards
(see figure C). Flip the bracket upwards (see
figure D). With your thumbs centred under-
neath the filter, lift the filter and pull it down to
remove it. (Variant: With flames)
You can use the test button
„ z
whether the welding helmet's darkening feature
is working properly.
You can adjust the delay setting
„ z
configure whether or not the auto-darkening
feature should be switched off immediately
after stopping welding work, depending on the
type of welding work. At the lowest setting,
auto-darkening is switched off immediate-
ly. Turn the rotary switch clockwise towards
the highest setting to prolong the time the
auto-darkening feature remains active after
welding work. This feature is very useful for
handling afterglow.
You can use the sensitivity setting
„ z
the light sensitivity of the sensor. With low in-
cident light, the control can be adjusted to the
highest setting to ensure that the auto-darken-
ing feature is activated even for a weak light
source. Even with this additional feature, you
can also adjust the light sensitivity of the sensor
to suit your own personal requirements.
The lowlight sensor switches the LED lamp on
„ z
in dark environments and off in brightly lit
environments. This helps to illuminate the object
being welded in dark working conditions. The
LED lamp can be switched on and off using the
14
lamp control . If the battery charge level is
too low, you can replace the batteries. To do
so, slide the left side of the battery compart-
15
ment to the left (see figure A). A low battery
charge level is indicated with a red warning
light on the display
10 GB/IE/NI
10
to check
11
to
12
to adjust
13
.
z Cleaning and Maintenance
Do not use any harsh cleaning agents to clean
„ z
2
the helmet casing
Never bring the UV filter
„ z
water.
Clean the product with a soft, dry cloth, with
„ z
a cloth dampened with pure alcohol or with a
cloth dampened with disinfectant.
z Environmental instructions
and disposal information
Don't waste, recycle!
The device, accessories and packaging should be
recycled in an environmentally friendly manner.
Do not throw the auto-darkening welding helmet
into household rubbish, fire or water. If possible,
non-operational equipment should be recycled.
Contact your local retailer for information.
.
8
into contact with