Publicité
In AUTO mode
The indoor unit operates in corresponding sleep mode adapted to the automatically selected
operation mode.
In FAN mode
SLEEP mode is unavailable in FAN mode
•
When a TIMER is set, Sleep function cannot be set.
•
After the SLEEP function is set, if the user resets TIMER function, the SLEEP function is
canceled. The indoor unit operates on TIMER ON. If the two modes are set at the same
time, either of their operation times is canceled first, the unit stops automatically, and
the other mode is canceled.
After a power failure:
•
Press the SLEEP button ten times within five seconds to enter Sleep function. 4 bip
sounds confirm that the remote controller entered Sleep function.
•
Press the SLEEP button ten times within five seconds to exit leave Sleep function. 2
bip sounds confirm that the remote controller exited Sleep function.
Power Failure Resume Function
•
If the unit is started for the first time, the compressor starts 3 minutes later.
•
When the power resumes after power failure, the indoor unit operates automatically,
and 3 minutes later the compressor starts.
4.3. Health airflow Operation
The HEALTH AIRFLOW operation set comfort operation conditions.
To set the health airflow function
1.
Press the EXTRA FUNCTION button
2.
Press this button continuously. The direction of the louvers goes through the 3 positions:
3.
Select a swing orientation, and press the CONFIRM/CANCEL button to confirm.
To cancel the health airflow function
1.
Press CONFIRM/CANCEL button to cancel.
•
Avoid adjusting the flap by hand. It could cause the grille to operate incorrectly.
•
If the grille operates incorrectly, stop the unit for a minute and start it again with the
remote controller.
•
After setting the Health airflow function, the position of the grille is fixed.
•
In cooling, it is better to select the
•
When the indoor unit operates in COOL and DRY modes for a long time in a very
humid environment, condensation can occur at the grille.
to enter additional options.
FONCTION +
mode.
41
Publicité
