Publicité
1. GENERAL INFORMATION
•
The distance between the signal transmission head and the receiver hole should be
within 7m without any obstacle as well.
•
The presence of an electronic-started type fluorescent lamp or a wireless telephone
is installed in the room can disturb the communication between the indoor unit and
the remote controller. The distance between the indoor unit and the remote controller
should be reduced.
•
Full display or unclear display during operation indicates that the batteries need to
be changed. Change the batteries.
•
If the remote controller does not operate normally, remove the batteries and reload
several minutes later.
Inlet grille
Air outlet
Anion generator
(inside)
Display board
1.
Signal receive.
2.
Room temperature display.
When receiving the remote control signal, displays the set temperature.
3.
Operation mode indicator (Lights up when compressor is working).
4.
WIFI.
OPERATION MANUAL
Air inlet
Horizontal deflector (adjust up
and down air flow)
1
2
Air Purifying Filter
(inside)
Vertical deflector (adjust left
and right air flow)
4
3
Emergency
Switch /
Manual
start
Display board
35
Publicité
