Publicité
Les langues disponibles
Les langues disponibles
Confirm the new setting by pressing the S
ous operation. The newly set value will flash for 2 seconds to indicate the confirmation and
storage of the new data. The data is stored, even if no key is pressed for 15 seconds.
When running, the appliance will cool the cell until the currently set operating
temperature is reached. Once the set operating temperature is reached, the elec-
tronic control unit will turn off the cooling unit until the temperature detected by
the probe rises by about 4-5 degrees. When this happens, the control unit will
turn on the cooling unit to lower the temperature until it returns to the set oper-
ating temperature.
This "on-off" mechanism is perfectly normal and is common in all refrigeration
equipment such as refrigerated bars, cabinets, display cases, etc.
Please note that the temperature shown on the control unit display refers to the
air temperature (very susceptible to temperature changes due to the opening of
the door) and not to the temperature at the core of the appliance, which is much
more constant over time.
Error messages displayed on the control unit:
MESSAGE
P1
P2
If one or more error codes are displayed, write them down, turn off the appliance then turn it back
on after 3-4 minutes. If one or more of the codes are again displayed, contact the dealer to request
technical support and inform them of the error codes.
Food storage
The following instructions should be followed in order for the appliance to perform at its best:
Put the food into the appliance after it has reached the desired temperature displayed on the
control unit. To avoid restricting air circulation, do not put too many products in the upper part
of the refrigerator;
Do not place hot foods inside the appliance (they must be previously cooled in a blast chiller) or
in unclosed containers. Always package and protect foods before putting them in the refrigerator;
Avoid opening and door frequently and for prolonged periods of time, and wait at least 30
seconds before re-opening the door.
Defrosting / Defrost timing (see Pic.3 - Section 8)
The control unit automatically performs 4 defrost cycles in a 24 hour period (once every 6 hours).
When the defrost cycle is active, the D
remains on. The timer begins from the moment the appliance was last turned on. To perform a
manual defrost cycle, just press the D
immediately begin. When finished, the defrost timer will reset itself so that no defrost cycles will be
performed for the next 6 hours. During manual defrost, the defrost light on the display will be on.
The defrost water evaporation is automatic on all models.
TRANSLATION OF THE ITALIAN ORIGINAL INSTRUCTIONS
ERROR DESCRIPTION
Faulty thermostat probe
Faulty evaporator probe
EFROST
EFROST
button within 10 seconds of completing the previ-
ET
EFFECT
The temperature is no longer being
adjusted correctly
The duration of each defrost cycle
will be exactly 20 minutes
LED on the control unit (LED no.1, Pic.3 - Section 8)
button (D
) for 3 seconds and a defrost cycle will
EFROST
SOLUTION
Contact the dealer
Contact the dealer
- 29 -
Publicité
