Metabo HPT NT 65A5 Manuel D'instructions Et De Sécurité page 18

English
USING THE NOSE CAP
● When detaching or attaching the nose cap,
be sure to remove your fi nger from the trigger
and disconnect the air hose from the nailer.
The nose cap is attached to the push lever tip to protect
the workpiece from scratches or damage. Remove in the
order shown below when not using.
1 DISCONNECT AIR HOSE FROM NAILER.
2 Put the nose cap to the toe of the push lever.
Nose Cap
When not using the nose cap, attach to the storage area
in back of the magazine.
NOTE
● The nose cap may reduce nailing depth due
to its thickness. Adjustment of air pressure is
necessary for readjustment of naling depth.
RAFTER HOOK
An included hook can be attached by using three M5 x 16
fl ange bolts which are included with the tools.
When the tool is detached from the hose and not in use,
the hook can be used to store the unit.
● When attaching or detaching the hook, make
sure the hose is detached and the nails are
removed from the tool.
18
WARNING
Push
Lever
Disconnect air hose
Nose cap
WARNING
(1) How to attach the hook
Hexagonal bar wrench for M5
2
1
Main unit
Fig. 1
• When attaching, use a hexagonal bar wrench for M5
(separate).
• Fix the hook (1) to the main unit in three locations
using the M5 16 fl ange bolts (2) (Fig. 1).
×
Fastening Torque
8.3±0.5 N m 6.1±0.4 ft.lbs
•
• The hook can be attached in any direction. Adjust the
hook according to the operating environment (Fig. 2).
(2) How to detach the hook
Detach the hook by reversing the aforementioned
steps for attaching the hook.
● When the hook is attached, operate only
with SINGLE SEQUENTIAL ACTUATION
MECHANISM
ACTUATION MECHANISM. For switching
between SINGLE
CONTACT, see the appropriate section in
"METHODS OF OPERATION".
● Disconnect the air hose when hook the unit.
● Do not hook on high or unstable locations.
Also, do not hook it to the body, clothing, belt
or other personal items.
Fig. 2
85±5 kgf
WARNING
and not with CONTACT
SEQUENTIAL
cm
•
and