Toro TimeMaster Mode D'emploi page 6

132-4470
Traction Adjustment
1. Attention; read the
Operator's Manual—1)
Loosen the knob by turning
it counterclockwise; 2) Pull
the cable(s) away from
the engine to decrease
the traction, or push the
cable(s) toward the engine
to increase the traction;
3) Tighten the knob by
turning it clockwise.
All manuals and user guides at all-guides.com
decal132-4470
2. Scan the QR code for
more information on
traction adjustment.
Setup
Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
Important:
To prevent accidental starting, do not
insert the key into the electric-start ignition until
you are ready to start the engine (electric-start
model only).
1
Assembling the Handle
No Parts Required
Procedure
WARNING
Assembling and unfolding the handle
improperly can damage the cables, causing
an unsafe operating condition.
• Do not damage the cables when unfolding
the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Rotate the upper handle so that it nests together
with the lower handle
both knobs on the handle to lock the upper
handle in place
1. Upper handle
5
(Figure 3), and tighten
(Figure 4).
Figure 3
2. Knob (2)
g016547