Sony STR-DA5300ES Mode D'emploi page 50

Tip
Press on the remote when "Please Press
ENTER." appears on the TV screen.
3
Press B/b repeatedly to select
"Yes," then press
4
Press V/v repeatedly to select
the auto calibration type, then
press b.
The measurement results are saved.
Parameter
Full Flat
Engineer
Front Reference Adjusts the characteristics
50
GB
.
Explanation
Makes the measurement of
frequency from each
speaker flat.
Sets the frequency to one
that matches that of the
Sony listening room
standard.
of all the speakers to match
the characteristics of the
front speaker.
Parameter
OFF
5
Press .
The exit screen appears.
Notes
• After reflecting the results of a compensation for a
frequency characteristic, signals with a sampling
frequency of more than 96 kHz are always played
back at either 44.1 kHz or 48 kHz.
• The frequency response measurement result is not
utilized in the following cases.
– The multi-channel input is selected.
– "2ch Analog Direct" is being used.
– Dolby TrueHD signals with a sampling
frequency of more than 96 kHz are being
received.
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low characteristics. The
measurement results may vary, depending on the
position of the optimizer microphone and speakers,
and the shape of the room. It is recommended that
you follow the measurement results. However, you
can change those settings in the Speaker settings
menu. Save the measurement results first, then try to
change the settings if you want.
Explanation
Sets the auto calibration EQ
to off.