Sony STR-DA5300ES Mode D'emploi page 49

Masquer les pouces Voir aussi pour STR-DA5300ES:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9
Measurement starts.
The measurement process will take
approximately 30 seconds with a test
tone. Wait until the measurement process
completes.
Note
You cannot measure the speaker height of the
surround speakers and the surround back speakers.
Set the position of the surround speakers from
"Position" in the Speaker settings menu.
Tips
• Operations other than turning the receiver on or off
are deactivated during the measurement.
• In the following situations, the measurements have
not been performed correctly or auto calibration
cannot be performed.
– when connecting special speakers, such as
dipole speakers.
– when using the zone 2/zone 3 function in zone 2/
zone 3.
To cancel the measurement
The measurement is cancelled when you
change the volume, switch functions, change
the setting of the SPEAKERS switch, or
connect headphones.
Confirming/saving the
measurement results
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the TV screen.
Note
When the speaker(s) is (are) out of the phase,
"Out Phase" is displayed on the TV screen.
The "+" and "–" terminals of the speaker may
be connected the other way around. However,
depending on the speakers, "Out Phase"
appears on the TV screen even though the
speakers are connected properly. This is
because of the speakers' specifications. In this
case, you can continue to use the receiver.
Tip
The displayed unit of distance for models for
US and Canada is feet. The unit of distance for
models for countries/areas other than US and
Canada is meters. You can change the unit of
distance use in "Distance Unit" in the Speaker
settings menu.
2
Press
to select "Next."
When "Save auto calibration (auto
speaker setup) results?" appears on the
TV screen, you can select whether to
confirm the warning ("Yes") or not
("No").
Follow the instructions of the TV screen
when you select "Yes."
For details on warning and error codes,
see "Message list after auto calibration
measurement" (page 51).
continued
49
GB

Publicité

Chapitres

Table des Matières
loading

Table des Matières