Abicor Binzel ALPHA FLUX 350 Mode D'emploi page 23

6 Putting into operation
1
1 Contact tip
2 Insulator
Fig. 1 Equipping the torch

1not for wire 2.4
6.2 Mounting the neck liner
1 Torch neck
Fig. 2
Mounting the neck liner
EN - 8
Equip the torch neck according to one of the following figures:
2
3 Set screw
4 Sleeve
1 Screw set screw (3), sleeve (4) and ceramic sleeve (5) to a length of
10.5 mm into the torch neck (6) by means of an Allen wrench AF 4.
2 Screw contact tip (1) firmly into torch neck.
3 Screw insulator (2) onto torch neck (6) by hand.
1
2 Inlet nipple
1 Unscrew the clamping screw at the handle and pull out the neck liner (1)
2 Insert the neck liner (3) from the rear into the torch neck (1) up to the stop
and measure the length.
3 Shorten the neck liner (3) at the front side until the inlet nipple (2)
terminates flush at the torch neck (1) and debur the edge.
4 Slide the torch neck (1) into the handle and secure it with the clamping
screw.
3 4 5
10.5 mm
5
6
3
ALPHA FLUX
6
1
Ceramic sleeve
Torch neck
2
3
Neck Liner