KTM Power Parts 63512966044 Instructions D'installation page 4

Scope of supply
1x bracket, ignition cover protection
1x protector
2x countersunk screw M5x10
3x collar screw M6x35
3x spacer
1x Metamoll
Preassembly
- Position protector on bracket (both included).
- Mount and tighten screws (included).
- Glue on Metamoll (included).
- Position spacers (included).
Assembly
- Lay vehicle on its side.
- Remove screws .
- Release the remaining screws of the ignition cover.
Place a suitable container under the engine. Engine oil may
escape!
- Position preassembled ignition cover protection.
- Mount screws (included) but do not tighten them yet.
- Tighten all screws on the ignition cover in a crisscross pattern to
10 Nm.
Final steps
- Check engine oil level, add if necessary.
4